Used a heat gun on the shrink tubes on the new element holders. The hinges were slid out a bit on the oven door. Took the screws on the hinges and loosed them to slide the hinges closer to the door closing. It looks a lot better. Explained a lot to her about the heat shrike tubing and how the hinges worked. She seemed pleased with the results and wanted to thank everyone involved.

"Board acting real funny, sometime it seems like it overfills, something the drain pump comes on, sometimes it doesnt. Wash motor is never coming on. Wash motor ohms out fine from board but fuse on board also checks good. Will replace board first and see if that brings wash motor back to life, if not then will need to replace the sump.; ordrng 1 W11460945 (Sump assembly) and 1 W11462458 (Control)"

Installed new connectors for all the burners and adjusted positing. Installed new knob and bezel. Cleaned door and bottom of oven. All checks out good.

"Now unit 104 Tore down, checked all moving parts, reversed drum wheels, checked blower, noise gone, running good"

Power at terminal block missing leg. Outlet good. Peeked in the outlet and the L2 terminal are spread pretty far apart. Adjust prong on cord to give better contact. Then ui came on and unit running with no issues. If issue comes back would advise replacing the outlet.