"Ms pic. Cooktop grates left with the oven are not original. After cleaning the cooktop igniter bases and caps, the 4 corner ones test good. The center burner needs the burner base w19333445, burner cap w10171140 and screw 4449154. The conso,e was curved down in the Middle,blocking the exhaust vent. Would need SS console w10318550, me,brine assembly w10840440and the control board w10826153. The lower oven needs sensor 7430P04460 also. Return Monday 4-20-26. Customer will,inspect parts on arrival.; ordrng 1 W10333445 (Center burner base) and 1 W10171140 (Center burner cap) and 1 4459154 (Screw) and 1 W10826153 (ERC) and 1 W10840440 (Membrane assembly) and 1 W10318550 (SS console) and 1 7330P044-60 (Oven sensor)"

"The freezer was tightly packed with food. The ice cream near the front of the freezer was firm and the ice cream near the back of the freezer was hard. There was no due visible today at the compressor and the compressor was running at 103 watts and on 0.87 amps.Because this unit does not have an Icemaker, there was an extra push on ground connector that had fallen diwn next to the heater.It could have been the metal against heater odor they observed. I wrapped the extra wire up higher, away from the heater."

"Washer has several issue, customer states its working on its own and its loud and the cycles arent right, checked error codes found F2e1 f5e1 f7e1 f7e5, stuck button error explains unit running itself snd it did try to start itself when I closed the lid the f5e1 lid lock error is likely nothing as lid lock is working fine, unit very noisy spun by hand checked under unit gearcase leaked everywhere unit would need full gearcase rebuild both f7 codes are from shift actuator due to leak need approval from warranty as parts are over $400; ordrng 1 W11454741 (Gearcase) and 1 W10721967 (Splutch) and 1 WPW10006384 (Belt) and 1 W10913953 (Shift actuator) and 1 W11158830 (Capacitor) and 1 W10889172 (Motor) and 1 W11124765 (Control), states that autho needed"

Verified continuous draining issue replaced control board ran calibration and auto test washer working properly now

New lid came with other parts ordered already attached though it did not show that on the part description replaced lid only other parts ordered were redundant new lid making good contact wuth top of washer washer operating properly