"Found machine with long fill error code. Tested machine, hot valve flowing normally but cold is running slow. Removed hoses and inspected valves, found some debris in valve from house side. Replaced valve with truck stock and installed hose filter washers. Instructed customer to replace washers regularly.; used 1 W11210463 (Valve) from stock"

"Found machine with bellows not fully installed and with a tear. Entered diagnostics mode and machine has error codes F0E2, F0E1, F6E3 & F7E9. Ran machine through diagnostics cycle, completed cycle with no errors. Acu has intermittent issue, ordered bellows and ACU.; ordrng 1 W11314648 (Bellows) and 1 W11322903 (ACU)"

"Replaced motor. Ran machine through calibration and diagnostics cycle, completed cycle with no errors. Ran machine on drain and spin, machine functioning normally. Ran on rinse and spin, machine keeps filling. Blew out water pressure sensor hose and ran again, still keeps filling. Checked pressure bell, some water droplets inside but not filling. Ordered control for bad pressure sensor.; ordrng 1 W11170317 (Control)"

Found machine with a burned wire at the block. Ordered block and harness.; ordrng 1 WPW10245259 (Block) and 1 W11416047 (Main harness)

Check dishwasher over for drain issue and found that drain pump chopper blade had broken and was jamming impeller. Replace drain pump with correct part and test and verify now draining properly.; used 1 W11497943 (Drain pump with chopper blade) from stock