"Ms pic. Water was coming from the left front corner into the drain pan. There was some dried water residue the drain catch basin and water on the left side of the catch pan. This indicates a little water has been seeping into the drain pan periodically. Since the left side was lower than the right side, it did not affect the float. Dried water residue at the corners, inside the tub, show a forceful water flow around the inside of the unit. There is a small U shaped piece below where the door and tub meet. This routes water back into the tub, if it seeped out at the corner. I elevated the left front corner and it tested good with no leaking. To minimize the forcefulness of the waters momentum going into the front corner, if the dishes were loaded with a gap between them, so the water sprays against the back dishs then the side of the tub, followed by the front dish, the momentum of the stet will be much less. I cleared the F8-E4 code from the computer."

"Ms pic tag is not legible. it has been cleaned many times and think is worn off. The customer had been cleaning the control, getting it moist, before it stopped working. ..power cycled unit and out it into diagnostics. It is working in bake and broil cycles. Advised to keep moisture away from direct contact with the touch pad.Collected $139.00 on check auth code LNW39Y"

"Was low on fuses. Replaced the magnetron and transformer. It ran longer now but still blew the fuse. The control board relay was open after it stopped working, so the board relay was affected by the previous instantaneous fuses going bad. Additionally needs the W11544456 microcomputer that is at DVH.The customer will check availability of schedules to see who is available for rescheduling. She will call the office next week to reschedule.; ordrng 1 W11544456 (Microcomputer), used 1 M0805101 (Fuse) from stock"

"Replaced the motor sump assembly and it tests good, showed the customer how to remove the filter and clean it. Tests good with no leaks."

Replaced the user interface and vent.tesyd good in the diagnostics cycle with no leaking. Collected the $90.00 labor on card@auth code TP4V3R.