Pull wall oven and replace both fuses and reassembled door and run a bake cycle and verify oven is now functioning.

Returned with part and install on gas valve and dryer was still dropping out during heat cycle. I tried an igniter and flame sensor still something. Called tech line and went through issue with Andrew and he recommended replacing main control board and I reassembled dryer and tested again and now dryer is functioning properly. Might have been a connection or control has started functioning but at this time unit is heating. Office is crediting customer $66.25 for part that I did not need to install.

Check gas dryer over for issue with heating and after pulling drum and ohming out thermostats I believe issue is with gas valve hold coil and will need to pick up part and have rescheduled return for this Thursday. Customer paid in full with credit card.; ordrng 1 WPW10328463 (Coil) and 1 Pleaseputonwillcall

Install new icemaker and ran test cycle and verified it did fill with water and will have to see if this fixes the issue with harvesting ice.

Check icemaker over for issue with not harvesting ice and verified icemaker functions but did not harvest on its own and freezer temp was minus 4 degrees. Ordering icemaker and need office to reschedule with customer when they have received part.; ordrng 1 W11700250 (Icemaker)