Need Appliance Repair Service? Have a general question?
We love solving problems! Let us know how we can help by reaching out below.

How can we help?

Local Reviews
for Carver, MN

Twin Cities Appliance Rated 4.7 out of 5 stars based on 3 customer reviews

Map of Carver, MN

Great experience




Review of Twin Cities Appliance


Map of Carver, MN

Irv




Review of Twin Cities Appliance

The people that came out to diagnose and to repair our refedgerator were great.


Map of Carver, MN

Quick service




Review of Twin Cities Appliance


Ryan W.

Ryan W.

REFRIGERATOR WHIRLPOOL WRX986SIHZ00 Installed parts charged to factory spec cooling when left give 24 hrs for temps additional for ice

Near Hackberry Ct, Carver, MN 55315
Joshua B.

Joshua B.

WASHER MAYTAG MVWB835DW4 Needed a new in.et valve installed. First valve I tried was a reboxed valve that the cold side did not work. Tried second brand new valve and all tested good. Both hot and cold work as they should.; used 2 W11165546 (VALVE) from stock

Near Cedar Ct, Carver, MN 55315
Joshua B.

Joshua B.

WASHER WHIRLPOOL WFW5620HW0 Water pressure is very high on the unit. Instructed customer to get water pressure arresters for his wall valves to relieve the pressure sounds when the water is turned off on the inlet valves. Unit is functioning as it should. Just very high water pressure is causing the thumping noise. Ran the unit through full diagnostic cycle and all ops working as they should. Just a pressure problem. Zero error codes on the unit.

Near Sibley Ct, Carver, MN 55315
Joshua B.

Joshua B.

WASHER WHIRLPOOL WTW8000DW5 Installed the new valve and tested. Unit is running as it should now.

Near Christy Dr, Carver, MN 55315
Joshua B.

Joshua B.

WASHER MAYTAG MVWB835DC4 Upon arrival customer informed me that they are using the clean washing machine function with afresh at least once a week. This might be a bit too much and unit is getting residue from the afresh. Ran full diagnostic cycle on the unit all ops good. Tested the water for hardness and it came up with 1.5 gag which is in the soft range. Used several different types of detergent and same results. Only conclusion I can come up with is using the clean cycle too much. Instructed to back off on the clean cycle to at the very least every 30 loads as is in the users manual. Nothing else we can do to change it.

Near Aspen Dr, Carver, MN 55315
Ryan W.

Ryan W.

WASHER WHIRLPOOL WFW9150WW02 Had f9e1 and F9e2 pump loud and impeller excessive vibration not draining at times needs new pump impeller failure quoted 85.90 labor parts shipping tax 260.37 nothing collected today will collect on return visit ; ordrng 1 SHIP (SHIP) and 1 WPW10730972 (pump-water)

Near Hackberry Ct, Carver, MN 55315
Ryan W.

Ryan W.

WASHER WHIRLPOOL WFW9150WW02 Installed pump had to get a extra clamp from fleet farm all tested ok draining now

Near Hackberry Ct, Carver, MN 55315
Joshua B.

Joshua B.

DISHWASHER WHIRLPOOL KDFE104DSS5 Zero error codes on the unit. Ran full diagnostics on the unit and all ops good. Unit is not mounted properly to the cabinets. Instructed to do so. Lots of soap in the unit. Instructed to back off on soap due to suds sticking to the dishes after the rinse cycle. Also instructed to use rinse aid.

Near Shady Oak Ln, Carver, MN 55315
Joshua B.

Joshua B.

MICROWAVE WHIRLPOOL WMH53520CS6 Replaced interlock switches with kit. Tested and unit working great; used 1 W11244490 (INTERLOCK KIT) from stock

Near River Rock Dr, Carver, MN 55315
Ryan W.

Ryan W.

DISHWASHER WHIRLPOOL KDTE334GBS0 Upper rack track broke need new tracks; ordrng 1 W10913628 (track) and 1 W10914507 (track)

Near High Bluff Cir, Carver, MN 55315
Nate A.

Nate A.

DRYER WHIRLPOOL WEL98HEBU0 Got picture of the Mac and said numbers and customer did as well. Followed directions in manual but saying the password was incorrect for network of dryer. Gave customer the number for whirlpool connectivity department.

Near Mt Hope Rd, Carver, MN 55315
Nate A.

Nate A.

MICROWAVE WHIRLPOOL WMH53520CS6 Customer getting the open and close door error message again. Installed updated switch kit in the unit. All checks out ok and is working correctly.; used 1 W11244490 (INTERLOCK KIT) from stock

Near Pebblestone Rd, Carver, MN 55315
Ryan W.

Ryan W.

REFRIGERATOR WHIRLPOOL WRS555SIHW00 Installed new freezer door icemaker cycled and filled give 24 to 36 hrs for ice

Near Ramsey Ave, Carver, MN 55315
Ryan W.

Ryan W.

REFRIGERATOR WHIRLPOOL WRX986SIHZ00 Customer states not making ice fast enough. Freezer -2 ff 37 icebox 8 to 10 degrees ice bucket full customer stated have not used in a day or 2. I advised that when ice bucket is empty it takes 24 to 48 hrs to fill time can depend on if using the ice while it is still trying to fill bin and how often ff door is being opened and temp is lost. No error codes for IM in test 56 all fans and thermistors pass icemaker operational unit is working as designed customer stated has worked this way since it was new which is normal operation

Near 6th St W, Carver, MN 55315
Ryan W.

Ryan W.

REFRIGERATOR WHIRLPOOL WRS555SIHW00 Fill tube frozen again in door tested fill tube heater which is getting 24 vdc homed heater for fill tube which is reading open bad heater must replace whole freezer door to repair fill tube line is not serviceable ordering freezer door customer to call when arrives ; ordrng 1 LW11026426 (dor-fip)

Near Ramsey Ave, Carver, MN 55315
Ryan W.

Ryan W.

REFRIGERATOR WHIRLPOOL WRS555SIHW00 Icemaker fill tube frozen thawed out all cycled and filled normal customer does have unit hooked to RO system does have filter removed from unit. Customer does use the RO faucet at sink a lot for filling pots etc very possible that icemaker filled when was using faucet cutting pressure back at that time. See how it performs in the next 48 hrs for ice production.

Near Ramsey Ave, Carver, MN 55315
Ryan W.

Ryan W.

REFRIGERATOR WHIRLPOOL WRF989SDAE00 "Found dye on evap looks like could be coming from where cap tubing meets evap or from cap tubing itself could be cracked. Also from leak unit must have moisture or bad oil because there is a restriction in system also unit would not run at all an has not been until reset power to it. Would need new evap assembly for ff section, ff evap drip pan, ui and main control board, evap cover, rear seal adapter kit, heater facia kit. Customer going to buy new unit"

Near Aspen Dr, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR JENN-AIR JFFCC72EFS00 No one home did not confirm called number listed no answer need to call and reschedule ; saved tckt

Near Ramsey Ave, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR WHIRLPOOL WRX986SIHZ00 W10843055 control at vadnais W11087438 fan at Sioux Falls W11330931 ui at whirlpool faulty that defrost sensor was faulty causing massive frost build up on ff evap also found in diagnostics comp wouldn’t stop running reset and comp is now cycling properly but need to replace boards customer scheduled for Tuesday ; ordrng 1 W10843055 (cntrl-elec) and 1 W11087438 (motor-evap) and 1 W11330931 (UI)

Near 6th St W, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR JENN-AIR JFFCC72EFS00 Installed parts due to frost build up in ice maker section

Near Ramsey Ave, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR WHIRLPOOL WRF757SDHZ00 Installed plate due to faulty sealing and tested

Near Woodview Cir, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR JENN-AIR JFFCC72EFS00 Found icebox door and plate having sealing issues frost building up in ice box and around ice box need to order W10793258 plate at whirlpool and W10853440 seal at whirlpool. Customer let me in and went up stairs no one explained their concerns about they might think is wrong went off notes and noticed sealing issue. Could not schedule return call with customer because after yelling hello and excuse me no one answered I left. Need to call and schedule return call ; ordrng 1 W10793258 (plate) and 1 W10853440 (gasket)

Near Ramsey Ave, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR WHIRLPOOL WRF757SDHZ00 Installed water tank no more leaks. Office to call customer on other part.; saved tckt

Near Woodview Cir, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR WHIRLPOOL WRF757SDHZ00 Need to order W11168758 water tank at vadnais and W10837274 chute at vadnais found chute has bad seal causing ice to melt also found small crack on tank. Customer scheduled for Tuesday ; ordrng 1 W10837274 (plate) and 1 W11168758 (WATER TANK)

Near Woodview Cir, Carver, MN 55315
Joshua S.

Joshua S.

WASHER WHIRLPOOL WTW7500GC0 Found hot water valve getting stuck open causing leak when washer is off. Installed w11165546; used 1 W11165546 (VALVE) from stock

Near Riesgraf Rd, Carver, MN 55315
Ryan W.

Ryan W.

REFRIGERATOR KITCHEN-AID KRMF606ESS01 unit not cooling nothing running on arrival no lights nothing would show up or run in diagnostics. Reset breaker then in diag all passes tests and now unit fully operational and starting to cool would need WPW10675033 CNTRL and W10894103 ui CNTRL customer does not want to repair anything at this time is going to call kitchen aid and get back to us

Near Vernon Dr, Carver, MN 55315
Ryan W.

Ryan W.

DISHWASHER MAYTAG MDB4949SDH1 Upper and lower rack wheel assemblies track and lower wheels falling apart will need all new office to contact customer for return date ; ordrng 4 W10195416V (dish rack wheel)s and 4 WP8565925 (stop)s and 8 WP9743002 (gasket)s and 4 WPW10078083 (dishrack wheel)s and 4 WPW10571738 (wheel)s

Near Sibley Cir, Carver, MN 55315
Joshua S.

Joshua S.

MICROWAVE MAYTAG MMV1174FZ0 W10899481 panel at whirlpool W11110847 board at Waterloo Iowa see notes

Near Kirche Hill Dr, Carver, MN 55315
Joshua S.

Joshua S.

REFRIGERATOR WHIRLPOOL ED5FHEXSB02 Installed Tstat

Near White Pine Way, Carver, MN 55315
Ryan W.

Ryan W.

REFRIGERATOR WHIRLPOOL ED5FHEXSB02 "TSTAT failure unit not shutting cooling down when temp satisfied will need new WP2315562 quoted 85.90 labor, 12.00 ship 97.95 diag parts tax = 293.34 customer paying in full with card; ordrng 1 SHIP (SHIP) and 1 WP2315562 (thermostat)"

Near White Pine Way, Carver, MN 55315