Twin Cities ApplianceJune 1, 2026 · Washer Repair
When an Amana NTW4519JW finishes a cycle and leaves your clothes sitting in water, the machine is almost always stopping itself on purpose. A top-load washer will not advance to high-speed spin if it cannot lock the lid, cannot drain, or senses the tub is unstable. So the trick is figuring out which of those it is. Most no-spin and no-drain cases on this model come down to a handful of parts, and a couple of them you can check yourself.
Start with the simplest possibility: load balance. A bulky item like a comforter, or a load shoved to one side, can throw the tub off balance enough that the control slows or skips the spin to avoid banging. Redistribute the laundry evenly and try a Drain and Spin cycle with the load balanced.
Next, the lid. These washers will not spin unless the lid is fully closed and locked. Press the lid down firmly and listen for it to seat. If the lid strike, the little tab that engages the latch, is bent or misaligned, the machine thinks the lid is open and refuses to spin. A strike that is cracked or out of position is a common, low-cost fault on top-load Amanas.
Then check drainage, because no-drain and no-spin usually travel together. Make sure the drain hose is not kinked and is not pushed too far down the standpipe, which can create a siphon. If the washer fills and agitates but never empties, a clog in the hose or drain pump is a strong suspect.
A power reset is worth trying before you go further. Press Power or Cancel to stop the cycle, then unplug the washer or switch off its breaker for about five minutes to let the control fully discharge. Restore power, open and close the lid once, then select a cycle and press Start. A reset clears minor control hiccups that can hold up a spin.
If the basics check out and the washer still will not spin, the cause is usually internal. The lid switch can fail electrically even when the lid looks fine, the drive belt can wear or break, and the motor coupling, two plastic pieces joined by a rubber center, can crack so the motor turns but the tub does not. A bad coupling often shows up as a machine that fills, agitates, and drains but will not spin, sometimes with a grinding or rattling sound. Worn suspension rods can also let the tub wobble enough that the control cancels the spin to protect itself.
Testing a lid switch for continuity, replacing a belt or coupling, or diagnosing the drive system is where a trained technician earns the call. These repairs require opening the cabinet and using a meter, and replacing the wrong part is a common and avoidable expense.
Twin Cities Appliance Service has been a family-run name in Minneapolis since 1957, and we are the only Whirlpool Factory Certified Care company in Minnesota, which covers the Amana lineup. Our trucks stock more than 126 of the fastest-moving parts, so most washer repairs are handled quickly, often the same visit. We see these no-spin calls regularly from Lakeville and across the metro, especially on hard-working top-load machines.
For the manufacturer’s own troubleshooting and your model’s manual, see Amana’s official washer support.
If your washer still will not spin or drain after these checks, schedule service and we will get you on the calendar this week. You can see the full list of brands and appliances we cover on our what we service page.
