Check dryer over for issue with loud screeching noise when heating up and found seized idler roller. Remove and clean shaft and install new roller and clean out and vacuum inside.; used 1 279640 (Idler pulley) from stock

"SR#7738662555Called tech line and spoke with Chris and went over issue with washer and what Ive replaced so far and he recommended replacing drive motor.; ordrng 1 IPickeduplocalatdey (I picked up local at dey), pckd up 1 W11026785 (Motor)"

Install new lower wire harness and ran diagnostics and tested all cycles and washer started every time so will have to see if it fails to start when customer dose some laundry.

"Check for fault codes and still none present and after replacing control I still got a issue during test run where it would not advance and went straight to done. Replaced actuator and run capacitor and ran calibration cycle and multiple cycles with out failure. Instruct customer to call back if still an issue and office would need to order wire harness. ; used 1 W11481722 (Actuator), and 1 W11395618 (Capacitor) from stock"

Ordering main control board do to sporadic operation and no fault codes present but they have had issues where it wont start wash cycle and gos straight to down and drain until they try multiple times before it will work.; ordrng 1 W11633359 (Control)