Found unit not draining vacuumed out water and removed pump found nail stuck in pump removed and tested. Collected for call and labor

WASHER MAYTAG MVWC416FW1 Ran diagnostics again this time had a speed fault. Cleared code and ran auto test and it passed ran unit on rinse and spin and as soon as unit would start to agitate it would pause. Found faulty actuator not recognizing it spinning causing error. Replaced w10913953 and tested. Unit ran through rinse and spin and was still running when I left call. ; used 1 W10913953 (ACTUATOR) from stock

WASHER MAYTAG MVWC416FW1 Unit got stuck in cycle. Reset and cancelled. Ran diagnostics no errors present. Ran calibration and manual test. Unit is working properly

MICROWAVE WHIRLPOOL WMH31017HW3 Frame was bent causing only bottom switch to engage pulled out and tested multiple times unit is working properly

WASHER WHIRLPOOL WTW4955HW0 Installed new control tested all ops ok