"Installed new eol harness and new console harness. Customer has since got the unit connected to the app and it updated. Said the upper oven was off on temp so preheated upper and lower to 350. Upper oven running right at temp, lower oven running a little low so adjusted calibration up 10 degrees. Advised trying convention and showed calibration if wanting to try turning it up."

"Installed new oven/fan/sensor harness. Tested operations, and both ovens hang at end of preheat, suspect possible low voltage issue, recommend preheating ovens offset or staggered."

"Checked the thermal fuse in line with board and was no power at fuse. Checked breaker and was tripped halfway just the upper portion and would trip right away. Took off all connections in junction box so just breaker and wire in wall and breaker still did the half trip. Tightened up all connections and reinstalled and then tried breaker one more time and didnt do the half trip and oven powered on with no issues. All checks good, if issue comes back would have an electrician replace the breaker."

Tripping breaker wont even reset removed panel Dont see anything visual with board all connectors seem to be in right place removed almost all connectors from board and still wont reset suspect could be issue in junction box let know if that is case or bad breaker we will have to refer him over to a electrician at that point did not want to have me remove unit and check junction going to call electrician to have them check breaker and junction

F2e1 bad panel installed new ui panel test ok part covered