Found comp running normally. Checked evap fan stalling. Pulled evap cover. Unit has full frost pattern. Replaced fan motor. Unit running and cooling. Advised cust. Will rts comp not needed.

"Tested machine, no heat and glow igniter not glowing. Tested flame sensor, bad. Replaced flame sensor and tested, heating normally.; used 1 WP338906 (Flame sensor) from stock"

"Ms pic.. They bought groceries on Saturday.On. Monday the compartments were both at room temperatures. Today the fresh food section is 67 degrees and the freezer was at 16 degrees.The compressor is running at 0.53 amps and 63 watts. It cycled off.when turning in on again wattage was at 1732 and it dropped down to 711, the down to the mid 60s. After it was running for a while the readings were 95 watts and 0.79 amps. The freezer frost pattern was good but cold air was not blowing up into the fresh food section. There was no venting obstruction. and the evaporator fan is working, but not at a strong speed. I believe we May be having 2 issues, an evaporator fan along with a compressor that is sometimes cycling off and the evaporator fan is too weak.Ordering compressor W11590057 and evaporator fan WPW10474673 that the customer will pay for if found to be needed on the return trip.Cole Ted $139.00 onCheck code V3H434. Return for 2 time slots on Thursday 3-38-24.; ordrng 1 Wpw104646873 (Evaporator fan) and 1 W11580057 (Compressor) and 2 Timel (Slots)s and 1 Sealed (System technician)"

Tested machine and when the evaporator fan was at its highest speed there was a vibration noise. Used some foam to absorb the vibration. Had customer confirm that the noise was gone.

Checked control for errors code. None found checked heater ok. Checked thermistors ok. Advised cust of unit operation.